Centroid Community CNC Support Forum

yeah if you bail mid homing cycle you can sometimes interrupt the cycle while the axes are un paired. there is a command that re-pairs them after it is square'd up in the home program...so, if you cancel out after it un-pairs but before it re-pairs then the machine is left in the un-paired state. a...

suntravel wrote: ↑Mon Nov 13, 2023 12:28 am If the farmer can't swim, it's because of his swimming trunks

Uwe

They also sell mirrors at the Dollar Store, those usually can help with identifying the root cause.

Chris, I haven't run into this issue with G30 until this release. I did not set Z value at 20.8099, this is being written by the Wizard. My max Z travel is set to 14 7/8". 20.8099 is my machine Y value for the touch plate. Can you help identify where the 20.8099 Z value is being generated? The ...

I know you are getting frustrated but maybe it's time just to start from scratch with your settings. Break it into sections and get each section working correctly. Reduce your max speed settings until you get the correct operation of the machine to give yourself more time to react to hit cycle stop ...

When I save the G30 settings to machine Z 0 then home the machine, that is when I notice the G30-Z value is being over-written with the G30 X value. If I save the G30 settings, then exit, restart CNC 12, then home, that is when I notice the over-write of G30-Z. It could also be over-written when zer...

If you hit Ctrl+P while in the wizard it will generate screenshots of all screens. Print to Windows PDF and save, then post PDF file here.

During re-calibrating my machine auto-square from prior issue, I discovered the following issue. I use G30 for my tool touch off plate to measure tool Z-Offset. The G-30 Z value is being over-written at what I presume machine homing or Z part zero to the Y value. I have been able to repeat the condi...

Installed 64 bit 5.07r14 last night, went to test cut today and ran into a slight problem Router with paired 2 & 4 axis autosquare, had to re-home and ran into an error with Y-travel exceeded, homing operation was interrupted, unable to move off of limit switch with MPG or VCP, exited CNC12, pow...

I ordered an Ox Laser module 5W from Amazon and made a mount on my dust shoe for easy mounting when I use it. Everything is packaged on the laser module (no additional boards/controls) so I just have a 4 pin molex near the spindle that I plug into the unit's pigtail, then use the mean-well power sup...

Glad you got it isolated and fix on the way.