Centroid Community CNC Support Forum

the 611 drives were made in both analog and digital drive bus versions. to verify you have the analog 611 drives and not the digital ones look for connector X321, terminal 56 and 14 are the +/- 10 v input and ref.
an oak board in velocity mode should work fine

the siemens 611 drives from that machine should be the analog ones, you should be able to run them with no problem from the +/- 10v analog signal from a centroid control. the siemens motors have the tach and hall effect signals feeding the 611 module and the encoder signal would feed the centroid co...

is the fanuc a dual path control that runs both turrets simultaneously?

I did not have this info when i posted but key is 0625071069 , lathe kit A50283, DF led on dc3io is out

Thanks for the reply. I removed the cpu board from my mill and put it in the lathe, the problem has gone away. So it appears that the cpu10b board is bad.

I have a cnc lathe with linux cnc10 v2.32 and a dc310 servo drive. I reconnected it after several years if in activity and now i get a 436 servo drive fault at power up, it had worked fine last time i used it. The bios battery is also dead and giving wrong date errors but i hope that does not matter...

hello
i have a ajax linux cnc control in use for several years. now it will not boot up. booting stops at this message
kernel panic :vfs: unable to mount root fs on 03:01
cnc10 v2.32 s/n 314070862
any ideas?
thanks
jon

i have one of your lathe kits installed on my lathe. i made a gang tool that holds seven tools at one turret position. each tool is a different tool number in the program. is there a way to run thru the program without having it stop at each tool change and having to press cycle start?