Centroid Community CNC Support Forum

Done. Had to scale the input, but that was not an issue.

Thank you very much!

All your responses have been extremely helpful! Thank you! The axis load meters are working. Parameter 57 change to 7 did the trick. That was actually going to be my next try based on the feedback you all gave me, but I was not sure of the value. So the spindle drive only has one analog output. It w...

Well I don't see the report attached - trying again.

Thanks for the replies. Report is attached - hopefully I attached it correctly. Parameter 57 is zero. The servo drives are Delta ASD-A2 - see pic. To clarify, I would like to display the RPM that the drive thinks its running. With sensorless vector mode and slip comp, the drive knows RPM pretty clos...

I have a M400 with an Oak Board running CNC11. I was under the impression that the bars below the axis position would display load - assuming its the axis drive loads. See pic. The bars are always blank. Parameter 143 is set to 11. Also - is there anyway to display spindle drive load and actual spin...