Centroid Community CNC Support Forum

Page 58: https://www.centroidcnc.com/centroid_diy/downloads/acorn_documentation/acorn_ether1616_setup_guide.pdf Read the top of page 54 to set a static IP address or set the jumpers to DHCP. Marty, I am familiar with jumper settings on page 54. The board came set to A0 address, which corresponds to...

I just added a photo to this topic showing the status of LED’s on E1616 board I received no error code or messages of any kind, but I checked the Ethernet connectivity with E1616 board by issuing ping command to IP 10.169.1.43 address in Command Line of the PC running CNC12. Screenshot 2021-05-03 2...

Page 4 of the 1616 user guide shows that the IP address that you listed is not valid. Please verify that the address you are using is the address listed in the 1616 documentation. The address on my computer is 10.158.41.1. The computer's subnet mask is set to 255.255.255.0, which means that the com...

martyscncgarage wrote: ↑Tue May 04, 2021 1:01 pm Arthur, please take the time to check your PC's ethernet adapter settings per the video....
Marty

I did Marty,

Marty, I noticed that he wrote A0, but he listed the IP address as 10.168.1.43 (which I assume was probably a typo because I know of no way to set the 1616 to that address; however, I included the note about IP addresses just in case it is possible to set the 1616's IP address to another subnet). H...

Page 4 of the 1616 user guide shows that the IP address that you listed is not valid. Please verify that the address you are using is the address listed in the 1616 documentation. The address on my computer is 10.158.41.1. The computer's subnet mask is set to 255.255.255.0, which means that the com...

I just added a photo to this topic showing the status of LED’s on E1616 board I received no error code or messages of any kind, but I checked the Ethernet connectivity with E1616 board by issuing ping command to IP 10.169.1.43 address in Command Line of the PC running CNC12. Screenshot 2021-05-03 2...

What does the LED Segment display on the Ether1616 show once the Acorn is booted up and CNC12 is running? Does it give you an error code? If it gives you a connection error, try swapping out with another Ethernet cable to the switch. I just added a photo to this topic showing the status of LED’s on...

What does the LED Segment display on the Ether1616 show once the Acorn is booted up and CNC12 is running? Does it give you an error code? If it gives you a connection error, try swapping out with another Ethernet cable to the switch. I just added a photo to this topic showing the status of LED’s on...

Did you do a FULL shut down of Acorn and the PC, then restart? As soon as you start CNC12 you will get a message noting the change and to accept it (If memory serves) Make sure the switch, Acorn and Ether1616 are on line before you start CNC12 Marty Yes Marty, I did full power recycle on Acorn and ...