Centroid Community CNC Support Forum

I'm an idiot and I figured it out.

tblough wrote: ↑Sun Nov 07, 2021 10:57 am Remember outputs on the Ether1616 start at 33:

Output 1 on Ether1616 with A0 address = CNC12 output 33
Output 2 on Ether1616 with A0 address = CNC12 output 34
Output 3 on Ether1616 with A0 address = CNC12 output 35
etc..

Ill try that but but even if I run code it still doesn't turn on.

TheKitMill wrote: ↑Sun Nov 07, 2021 10:22 am Hi It looks like you have the Relay Board hooked directly to the Acorn Board and you are connected to output 8. Try forcing output 8 and see if it turns on the relay you are connected to.

I have my E1616 mounted under my Acorn. I have DC circuits on the left and AC on the right.

RogDC wrote: ↑Sat Nov 06, 2021 10:44 pm Is that the correct relay board for the Ether1616?
Can you attempt to force any of the other outputs from the Ether1616 into the correct state?

That is the relay board that came with the Ether1616. No I cannot force any other outputs for the Ether1616.

Hey everyone, This is something I have been trying to figure out for awhile now and I am too the point where I need to ask for help. I have my spindle cooling fan on one of the Ether1616 outputs and when I either run a job or force the output nothing happens. It is as if my ether1616 did not get the...

cncsnw wrote: ↑Tue Oct 19, 2021 11:49 am Do you mean a cutting and engraving laser, or a sighting laser for part alignment?

Sorry never got the email about you replying. I am talking about cutting and engraving with the laser. Then switching over to use an end mill.

Hey Planning on adding a laser to my router. Is there a work flow or guide to switch between the laser and the spindle? Also If I mount the laser on the side of the spindle is it possible to get up offsets from the center of the spindle?

Thanks,
Brent

It is getting 12v going forward.. I ordered a 12v power supply so I can try that instead of having to drop the voltage down from 24v to 12v.

Got it figured out!!!!!!

Changed settings to
849: 20 (wondering if the motor is dying)
850: 0
851: 2 (If I didnt change this instead of stopping on tool 1 it would roll back to 6)

WOW sorry for getting distracted again. Here is a video of the screen capture. I have tried to play with setting and nothing has changed. What sucks is that I only get that time out message.