Centroid Community CNC Support Forum

How to set up the axis is described here:

https://www.centroidcnc.com/dealersuppo ... ads/36.pdf

Encodercounts in Acorn must match to the setup of drives.

Uwe

M5 tapping



Uwe

terbospaghetti wrote: ↑Sat Dec 25, 2021 12:04 am Now I'm just gonna do it to spite you

Glad we could help you

Uwe

by the way, the reason why I was sure it works with the JMC was that we are tapping M12x1.75 in series on a Traub TNL16g bored up to 22mm. 1kw Mitsubishi Servo for the driven tools, 4.6Nm rated at the tool holder drive shaft which is 2:1 reduced in the toolholder https://up.picr.de/42692595pg.jpg ht...

ok. on a late you must build some enclosure for the board on the stepper.

I would connect them to the DB25 with a breakoutboard like any other stepper.

For the powersupply, I would ask the seller what is recommended.

Without drive ok signal, would not let them run unattended

Uwe

Hi, they are expensive, not cheap.

For 108$ you can have bigger and faster ones from Stepperonline, sealed, with wiring and powersupply.

https://www.omc-stepperonline.com/close ... cable.html

Uwe

For simple 2d paths I use Intercon, you can also import DXF and generate the g-codes with Intercon. Text and Logos engraving Inkscape for drawing and its G-Code tool. Complicated 3d parts fusion 360 Best is to learn to make g-codes only with Notepad++, helps a lot to dial in postprocessors or for op...

I think you will be doing well to manage M16 tapping in steel - Kennametal reckon 23Nm would be required. https://www.kennametal.com/us/en/resources/engineering-calculators/holemaking-calculators/tapping-torque-and-horsepower.html With 5.73Nm and 1:1.63 you may be talking 3.5Nm. Besides, I can't im...

If size is a problem, compare Haimer to TopCom:



Uwe

tech bulletin 270, this is lost Ethernet connection.

Probing stops if you have lots of request for resend in your logs.

Could both be a problem with noise or the setup on your PC.

Uwe