Centroid Community CNC Support Forum

I am having random fault issues, I have purchased three DYN4 drives 10/21/19. I have a Acorn board and there cables but still i am having issues with faults. They are telling me its setting issues but they will just fault out sitting there, some times when there Active High and Low. I just worked th...

Yes, my apologies i will post it over there i just wanted to let you all know I had Drives from the same time frame. Thanks Again

I am having random fault issues also, and I also purchased my DYN4 drives 10/21/19. I have a Acorn board and there cables not a Oak, but still i am having issues with faults. They are telling me its setting issues but they will just fault out sitting there, some times when there Active high and Low....

Upon pressing Alt-D both Machine and WCS #1 (G54) are the same X0 Y0 Z0.

And i went through your setup and set Part Zero for each axis. (which they all said 0.0000 already.

Ok, i started working through your list and didn't clearly see i anything about X0 and how it could have changed. Then I am not to work coordinates yet either because i didn't have homing set correct yet so those topics didnt present anything i seen. But during reading through things i came across s...

Did you assemble all of this on the bench first and do a bench test? Nothing should be connected to the machine until you ascertain that all drives and motors are working properly. Yes, I did all the bench test on all three Drives and Motors and everything worked as intended without issues (but ther...

I am having issues with my DMM Dyn4 drives and 750w AC Servos 86M-DHT-A6MK1. First issue I am having is with homing for the X axis. I hooked everything up and home the switches and everything seem great. But when I started running some commands to check accuracy, I found issues in the X axis. After ...