Centroid Community CNC Support Forum

I don't see your posted model number in the manual that you posted a link to. Are you sure you have the correct manual or did you type the model number incorrectly? In the manual you linked to it states that AI1 is for -10 to +10V and that's not the input you want to use. You need to use AI2 which i...

The only thing I think I can make out from that video is that you have X and Y setup backwards or you are confused about Cartesian coordinate system. X is left to right movement and Y is front to back.

Have a look at your error log, it is littered with communication errors, this is why it wont run a file. You MUST fix this issue first before you can proceed. Read this document below, until you fix this issue nothing will work correctly. Did you run the com stress test? There's no way it would pass...

Philip, we'd love to help but we need a lot more info to be able to help you. Please read this topic and post the required info so that we can see your system setup and offer up the best help for you. At an absolute minimum we need a current report from your machine. We have no idea what your "...

I agree with Scott, sounds like a bad connection somewhere. Go through EVERY screw terminal on EVERY board and check each connection and re-tighten it.

Since these are Clearpath you obviously cant swap the driver.

I also see that you asked this same question in the plasma forum, there’s no need to ask the same question twice in different topics, it only creates confusion to those trying to follow your build and for those that reply.

Be sure and follow the spacing requirements for the RX and TX boards in the manual. And as requested already by Joey start a Google album and take pics of your layout and wiring so we can see everything you see and help you. Post a link to that album here.

You can run those drives on Acorn. You can try to wire them up the same as the Y series drive but if it were me I would wire them to the DB25 using a breakout board for more reliable operation. I’d wire them like the CL86T diagram. Just start with ONE drive and ONLY wire up the PUL and DIR terminals...

Please post a current report when asking for help. See the forum post below.

https://centroidcncforum.com/viewtopic.php?f=60&t=1043

What wiring diagram did you follow? Is the switch on the drive set to 5V? Is the enable line hooked up of not? Do the drives lock when powered up?

Please post pics of the wiring and a current report. We need a lot more info to be able to help you.