Search found 373 matches
- Mon Nov 13, 2017 3:24 pm
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: ABB Microflex Servo and OAK connections <<Answered>>
- Replies: 3
- Views: 2209
Re: ABB Microflex Servo and OAK connections
Hmmm... It looks as if I answered while still asleep. Yes, you had it correct all along.
- Mon Nov 13, 2017 11:04 am
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: ABB Microflex Servo and OAK connections <<Answered>>
- Replies: 3
- Views: 2209
Re: ABB Microflex Servo and OAK connections
The Oak Fault input must be pulled to 24 GND. It is sourcing (+24V comes out of it), so it must be connected to a sinking output (to pull to 24 GND). On figure 24 of the "Drive status output" page, pin 23 should go the the fault input, and pin 2 to 24 GND. From the figure, there is no reas...
- Tue Oct 17, 2017 3:52 pm
- Forum: Centroid Oak, Allin1DC, MPU11 and Legacy products
- Topic: What makes a DC motor unidirectional?
- Replies: 3
- Views: 2141
Re: What makes a DC motor unidirectional?
The commutator could also be set to have some lead angle. This would allow the motor to run faster in one direction.