Centroid Community CNC Support Forum

Welcome to the forum. Thank you for the Report. Can you please attach the Gcode jobs you are running when the Z locks up. I want to see the Gcode job you a using. You best chance at having a working Plasma table with the Acorn is to Download and install Acorn Plasma software. Your current software i...

Checked out the Latest Plots yesterday The Last Plot was not looking good. Tiny Man Plot.png Turn the Plot capture on in the F7 Utility menu and dry run some jobs. This will capture plots without the torch running to see what the Cabinet is showing. Refrain from firing the Torch until this is resolv...

I would double check the divided voltage lines going to the TX board from the Hypertherm to ensure the Correct pins were used on the Hypertherm. In your picture the red going to the ANLV and Black to the GND make me nervous. PIN 5 from the Hypertherm is the Negative of the Devided voltage and goes t...

I think this has something to do with the calibration when the first TX was damaged.

Try a fresh install to get back to 0.

You can select CTR P when on the wizard to save the Wizard settings with print to PDF.

No problem

The THC should be set to installed during the Torch calibration.

Can you post a picture of the profile and THC config settings?

Since these file were the only ones I've tried on 5.10RC3, I thought I better try some others that have many short segments, and I see that it affects many others as well. I have this file (starts at the 1 minute mark) https://centroidcncforum.com/viewtopic.php?p=20948#p20948 that has a lot of spir...

I've Created a short walkthrough video of the 4inch line plot.

https://photos.app.goo.gl/8JZ3ZBamVvZSxFRr8

Joey, Thanks for the help. And patience. I Will redo the Torch calibration, To confirm from the posts,I can gather from your replies and help that the Plots look good, and the grounding issues are fixed and I'm good to do further cutting without damage? The Dry run plots would of shown the interfer...