Centroid Community CNC Support Forum

Thanks for the reply but i`m not sure where i should be looking for the code is it in the post Processor i use in fusion 360. is it in this section i need to install the command for G90/G91. Cheers. // define home positions var _xHome; var _yHome; var _zHome; if (method == "G28") { _xHome ...

I have this same problem on my mill where abouts do you install the code is it installed before the M6 code or at the beginning of all the code. Cheers. % O01001 (Clock Bracket Mount v5.5) (T1 D=8. CR=0. - ZMIN=-30. - flat end mill) (T17 D=8.5 CR=0. TAPER=118deg - ZMIN=-40. - drill) N10 G90 G94 G17 ...

Trialnterror wrote: ↑Sun Dec 27, 2020 5:52 pm Hey when you did your Bridgeport conversion did you loosen the clockspring on the quill? Assuming you did 3 axis?

No i just run everything as normal and everything seems to be ok.

Hi All. I`ve just completed my Bridgeport Diy conversion which is all up and running now I have the Allin1DC and i purchased the KP-3 Touch probe which is also all working fine i just need to know does anyone know how to convert the files from centroid to work in fusion 360 after doing a Digi scan.A...

OK so i managed to get the KP-3 running properly today and did my first full pass on grid setting.
So now hopefully i will be able to get back to normal now as i`ve missed using my mill.

It`s the KP-3.
Yes i`ve checked the videos and searched the forum i did some more tests on the other digi programs and worked ok but the one i want to use only works for about 5mm then cancels it`s the digi Grid one thats giving me a problem.
Paul

Hi . OK i got my probe all up and running managed to do 1 full pass on something it did`nt come out to good but ok for first try but now it goes for about 5 mm and just cancels i`ve tried a few different ways but just seems to cancel on it`s own out of the blue. Any help would be appreciated . btw i...

Had to change Para 218 - Value 7 - 3 Axis Mill/Router.
Then Software restart.
Now just waiting for the prob to arrive Which says should be here Monday.

Paul.

This helped a lot cheers marty Wmpg is working again.
I`ll get a fresh report done tomorrow.

Please post a fresh report.
Go into Parameters and make sure they are set correctly for the WMPG.
Set Tech Bulletin 313
https://www.centroidcnc.com/dealersuppo ... ds/313.pdf

I`ve upgraded to ultimate now but my wmpg has stopped working if i press the mpg button on the vcp it doesnt light up i`ve checked the parameters and they seem to be ok.
all there is on the wmpg handset is the signal strength and battery.
any ideas