Centroid Community CNC Support Forum

thanks for the input i found this video to be very informative on rigid taping installation . in my case encoder is on the motor . not 1 to 1 i do see a hookup for a haas option ridged tap wire and plug my guess theirs a spindle mount encoder option since it needs to be 1 to 1 to the encoder . this ...

I'm posted this in acorn section also incase hickory users don't read acorn. i been doing a haas mini mill upgrade 2001 i been gathering information on how to prosed. doing my homework keep in mind this is a haas mini mill 23 years old in has 1000 operating hrs so it hardly used it like brand new. i...

i been doing a haas mini mill upgrade 2001 i been gathering information on how to prosed. doing my homework keep in mind this is a haas mini mill 23 years old in has 1000 operating hrs so it hardly used it like brand new. i just hate controller. kind not haas fan boy . i chose this mill it step up f...

i understand the part of the encoder and what it can do . The spindle on haas mini is timing belt driven . the encoder timing belt ton the top of the spindle motor so that all good . the hickory uses encoder to oriant the spindle i get that part what i don't get is if doing rigid tapping there need ...

theirs no change gears this haas mill . the encoder connects to the motor shaft

this on haas mini mill the haas setup uses a dc powered servo amplified 320 v dc input same voltage connect to the other servo drives powering yaskawa ac servo The larger amp powers the spindle . it think it 45 amp model . it wired to the spindle motor the label says low voltage it only wire label n...

that the drive everyone telling me work delts C2000

But were does one buy a delta from direct from delta

was looking at a automation direct they say it full plc drive for the io . GS4-2025 DURApulse GS4 series AC high-performance drive, NEMA 1, 230 VAC, 25hp with 3-phase input, 10hp with 1-phase input, SVC or V/Hz mode, C frame, RS-485, Modbus and BACnet, 100kA SCCR. Optional EtherNet/IP and Modbus TCP...

hickory ethercat haas mini mill 2001 . spindle motor curently use ac 320 volt using a haas servo amplifier i know i have to replace the haas drive this something motor 800 rpm looks like 3 phase motor 10 hp there no tags question what would be my best choice make model on VFD to control the spindle ...

hickory ethercat haas mini mill 2001 . spindle motor curently use ac 320 volt using a haas servo amplifier i know i have to replace the haas drive this something motor 800 rpm looks like 3 phase motor 10 hp there no tags question what would be my best choice make model on VFD to control the spindle ...