Centroid Community CNC Support Forum

Shit, sorry, i had a brain fart. It's a 1920x1080 screen. So CNC12 is 1080 wide.

No way to switch them back to how they used to be? They were good as gold before. And to be honest I liked them in that old format better. They were more discrete. I rarely use them, and I assume others who use good CAM software rarely use them. But very occasionally when I am too lazy to generate g...

Screen is 1024x768, but running vertically. Cnc12 is docked to top of screen so is 768 wide.

Not sure on % of windows zoom. Would have to check that. I would assume 100% as everything else seems normal.

I will check zoom and make a report within the next few days.

What sort of commands have you been making the delta drive do? You can control almost anything with a PLC program. Usually it would start by writing your own M6 g code macro. This can set PLC flags that can be used to control IO pins. The built in Centroid carousel stuff does tool changes by sending...

I think its pretty well laid out in the Oak wiring examples. Look in the link below and search Delta. There is only a handful of wires to hook up, maybe eight. Even less if you are not using a motor encoder. I have an Oak and Delta VFD on my machine. I don't remember where my wiring diagram is for i...

I have a Hitachi SJ-P1 P1-00228-L VFD and P1-FB encoder card. Both are in as new condition. Used for a few mins of running. This is quite an advanced VFD, has all the bells and whistles. Can work on permanent magnet motors and induction motors. Can do spindle orientation on induction motors. Wiring ...

Today I upgraded from 4.17 (from memory) to 5.08. I just ran the installer and for the most part, everything just went and worked. I came across two little issues. The first is that the G code display has changed and looks a bit grotty on my screen. Is there any option to change back to the old G co...

Today I upgraded from 4.17 (from memory) to 5.08. I just ran the installer and for the most part, everything just went and worked. I came across two little issues. The first is that the G code display has changed and looks a bit grotty on my screen. Is there any option to change back to the old G co...

Today I upgraded from 4.17 (from memory) to 5.08. I just ran the installer and for the most part, everything just went and worked. I came across two little issues. The first is that the G code display has changed and looks a bit grotty on my screen. The font size is a bit large and it runs off the r...

So I couldnt help myself and looked in the manual. There does not appear to be a pg01lu encoder card. There are pg01l, pgo1o and PG01U. L is a differential input card, O is an open collector. These work on encoders that have only a A, B and Z signal. The U version, which is what I use is for encoder...