Centroid Community CNC Support Forum

ShawnM thank to look into the manuel for the informations . I also place into the PN (parameter edit mode 3.2) some as PN001=9 ... THE one that I want to have your advice on is the PN 098 ,099 ,100 , 101 as nominator as in fraction x/y and the PN 102 as denominator . X at PN098 as 10 the other have ...

Hi
I have a chinese servo drive and motor . I place in to the drive a kind of ratio . I would place tomorrow the link for my manual and verify it .
The information above are for stepper and servo or only stepper .

Now the initial question was , can you answers it That is my machine . The thing is after the post I find a post by Sword explaining a bit what is the smoothing setup , Then the light went on , that is the answer to my problem . All the trembling , shaking and bad word that go with it are finish. hi...

As hardware did I fulfill the minimum requirement of centroid now.

I just , last night , order a new pc that will should have a less 2000 at the benchmark with 8 gb ram and a 120 g ssd.

https://photos.app.goo.gl/bTsU16J6G1sCd1Gm9 That is my machine . The thing is after the post I find a post by Sword explaining a bit what is the smoothing setup , Then the light went on , that is the answer to my problem . All the trembling , shaking and bad word that go with it are finish. hip hip ...

I would not pay for a conversional software that I would not use . If I make my hole with a spiral or a boring pattern instead would it be the same for the test .

Hi I want to make smooth hole in plastic and each time it kind of vibrating or shaking at the direction change . So at 3 o'clock and 9 there are somme kind of grouve or difference between the smootheness of the hole . Q : On what variable I should play with for making it round and smooth . thanks Al...

How can I change the rpm of my stepper motor rotaty axe . For now it is very slow .
I have one connection on X ,Z the Y and Yslave and A rotary .

Ok Marty that vfd will be wired on a acorn board . Model is E550

https://www.simphoenix.com/uploads/dc24dd85.pdf
Thanks Marty .