Centroid Community CNC Support Forum

Gary, I tried setting input 5 to unused and NC and it WORKED !! Now onto mounting the Motors

Gary, Its not an issue with the DMM motors, I wired them up and the axis motors run fine. Its the output relay signal in the software. For instance when you turn off auto spindle and click spindle start, output 4 should turn green but I get nothing. I loaded CNC 12 on my laptop this morning and got ...

Here is a screen shot:

no spindle brake. I can manually turn on the relays using the diagnostic screen and the spindle runs fine, but the software won't trigger ANY outputs including spindle Fwd, spindle Rev, coolant, etc...

in the attached pictures I have the spindle on at 100 percent and none of the spindle outputs are green. Hope this helps. It seems like the software is not sending any output signals on the outputs for the relay board.

I'm retrofitting a Southbend Magnaturn 612 with the acorn board and DYN2 AC Servos. All has gone fairly well so far. I have it to the point where the axis motors work and just wired up the spindle. The spindle is the first thing I've hooked up to the relay board. I did the diagnostic bench test on t...

Thank you ! That would be Great !

Its partial touch screen and partial keybord and jog panel right now. I am working on getting more of the original jog panel hooked up right now. It would be nice if the centroid on screen jog panel could be dragged down below the dro and worked with the touchscreen.

Here is a youtube video of it drilling a hole then thread milling it to accept a 3/8 - 16 bolt. This was my first test on the machine.

Here are some pictures of my Fadal retrofit project.