Centroid Community CNC Support Forum

my dyn4 cheat sheet.

not typically. smoothing is primary designed for short vector 2D and 3D G code files and does a nice job rounding off rough G code files. or for helping out high speed routers turn corners running at fast rates. Intercon does not create short vector g code files.:-) so typically you would not use G6...

just introduced by Arturo at CNC4PC..by far the easiest way to connect Clearpath Motors to the Acorn CNC controller.
https://www.cnc4pc.com/c86accp-clearpat ... oller.html

fyi... we just updated the beta grey code plc program and instructions for lathe turrets.
https://www.centroidcnc.com/centroid_di ... s_rev2.zip
from this thread..
viewtopic.php?f=63&t=1340&p=7671#p7671

hello!
not sure what your question is.. check out the operator manual for info on how G code smoothing works.
https://www.centroidcnc.com/centroid_di ... -v4.14.pdf

please find attached a sample entire system Acorn schematic.

Hello. the schematic I attached is just half the estop circuit the other half should fire a contactor and kill the power to the VFD and the servo drives. we've had several dealers and resellers in the past use Centroid products in Europe and pass CE standards it's completely up to the installer to m...

the Acorn PLC program controls such things as how a safety door switch functions. the PLC program can be edited any number of ways to achieve the desired functionality and action of all types of safety switches, light curtains etc.. here is a link to a tech bulletin describing how to add a simple do...

thanks for reporting back... not following the schematic right out of the box?
also.. your report shows 'steps per rev' at 400... things will work much better at 2000. take a minute to read this post.
viewtopic.php?f=63&t=1801

hello. which drive type did you select? are you still on bench test? if so, bench test defaults to a "NO" estop since most wont have an actual estop connected for the communications test. if you have a estop wired, change input 8 estop to "NC" in the wizard. press write settings ...