Search found 17 matches
- Wed Sep 21, 2022 9:19 pm
- Forum: Acorn CNC Plasma
- Topic: plasma collision error
- Replies: 28
- Views: 4257
Re: plasma collision error
Which reves need changed will gladly change them. Not sure why the photo album isnt working it loads right up from that link for me. Maybe because I posted it. Never did a album before. Will change the resolution as well thanks.
- Wed Sep 21, 2022 8:34 pm
- Forum: Acorn CNC Plasma
- Topic: plasma collision error
- Replies: 28
- Views: 4257
Re: plasma collision error
Here are some pics.
https://photos.google.com/album/AF1QipO ... qvChKVdkdD
https://photos.google.com/album/AF1QipO ... qvChKVdkdD
- Tue Sep 20, 2022 5:52 pm
- Forum: Acorn CNC Plasma
- Topic: plasma collision error
- Replies: 28
- Views: 4257
Re: plasma collision error
Will do had a blond moment when restting them. Forgot I updated lead screw to ball screw on the z axis leads were 2 turn ball is 5 it caused my z not to react fast enough and had some drags. Also had my z drive quit for some reason after I finally had everything set right did reset fine but I ran ou...
- Tue Sep 20, 2022 4:54 pm
- Forum: Acorn CNC Plasma
- Topic: plasma collision error
- Replies: 28
- Views: 4257
Re: plasma collision error
Thanks everyone I set my rev's and motor to what you reccomend and still had the issue. At least Im set right now However when I removed my touch off wire the problem went away. Then I put it back on and pulled from the torch to check the wire all good. Turns out the the consumables I bought are jun...
- Tue Sep 20, 2022 7:55 am
- Forum: Acorn CNC Plasma
- Topic: plasma collision error
- Replies: 28
- Views: 4257
Re: plasma collision error
Powermax 45. Will watch vid on setting up google and get my axis settings changed.
- Mon Sep 19, 2022 9:01 pm
- Forum: Acorn CNC Plasma
- Topic: plasma collision error
- Replies: 28
- Views: 4257
Re: plasma collision error
It doesn't go down to touch off. Clamp is mounted to the table. It also starts the torch for a millisecond which allows post airflow but no ignition. I can use the momentary torch test and it fires up even with error showing on the screen. Im running a Gecko G540 leads are 5 turns per inch and motot...
- Mon Sep 19, 2022 7:14 pm
- Forum: Acorn CNC Plasma
- Topic: plasma collision error
- Replies: 28
- Views: 4257
plasma collision error
Hey guys having an issue and not sure what Im doing wrong. Im getting an error Nozzle collision or short Jog to clear torch cycle start to continue.
This happened after touching off and cutting first hole on the bear and moving to the next touch off. and help would be appreciated. thanks
This happened after touching off and cutting first hole on the bear and moving to the next touch off. and help would be appreciated. thanks