Centroid Community CNC Support Forum

Allthewatts wrote: ↑Mon Apr 15, 2024 10:28 pm How did you hookup the individual drives? Curious if you have photos of the box and layout! Thanks so much.

not a mill but emco lathe start to finish.
https://centroidcncforum.com/viewtopic. ... 4&start=10

post a fresh report.zip we will look it over and give you advice in general and on other stuff we see in it

make a photo album of your project, #3 here shows how.
http://centroidcncforum.com/viewtopic.php?f=60&t=1043

hi, please put all the photos in a online google photos album here is how. #3
https://centroidcncforum.com/viewtopic.php?f=60&t=1043

post a fresh report.zip otherwise we are all just guessing

Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043

use the Wizard to configure your probe.
the message is telling you cnc12 thinks a probe is plugged in and in the spindle since you must have a probe detect input defined in the wizard, either defeat it, configure it properly or remove it.

others have also used differential drivers for connecting Acorn/AcornSix to these drives and others like it to make use of the noise resistant differential step and direction signal.

https://shopcentroidcnc.com/shop/cnc-ex ... out-board/

i would review the parameters set in the yaskawa drives, what command mode do you have the sigma 2's in? if memory serves there are two step and direction modes

Ok, no problem, I believe it happened when I was using auto Z to plate. Gcode file that was loaded at the time did not refresh view wise. Any timeframe on testing for the router specific rework? Bill report_E062346A1C67-0716214939_2024-04-16_15-48-18.zip as soon as v5.1 is released i will have a v5...

avp wrote: ↑Mon Apr 15, 2024 5:03 pm Character display problem now. Same version 5.1RC5
IMG_8897.jpeg

we are having hard time reproducing this one.

i would try a smaller sized USB stick, the old linux controls could only go up to a certain size stick