Centroid Community CNC Support Forum

if you are not going to rigid tap on the W axis, independent Z axes can be controlled with G code, you could simply have your post processor put W in the G code for the 2nd Z axis when you want that 2nd Z to move and then the W axis would move not Z M333 is not sorted and is experimental, not sure i...

thanks, busy day working with Delta Drives and Hickory, just getting around to looking at the forum now.

CNC12 v5.1 RC#6 Mill, Lathe, Router, Plasma RC5 now available for download and testing. Models: Acorn, AcornSix, Hickory, Oak, Allin1DC, MPU11 Download link https://centroid-support.filemail.com/d/hmudxsfolvbjbeq?skipreg=true&pk_vid=90c44244f862018e17133063393e70b5 changes from RC5 Fixed M115 no...

ok cool. please install v5.08 or better yet v5.1 release candidate #6
https://centroidcncforum.com/viewtopic. ... 632#p86632

in you current version
open the wizard press CTRL P and save the pdf to the desktop.
then install the new version of CNC12 following the guidance in the setup document.

Allthewatts wrote: ↑Mon Apr 15, 2024 10:28 pm How did you hookup the individual drives? Curious if you have photos of the box and layout! Thanks so much.

not a mill but emco lathe start to finish.
https://centroidcncforum.com/viewtopic. ... 4&start=10

post a fresh report.zip we will look it over and give you advice in general and on other stuff we see in it

make a photo album of your project, #3 here shows how.
http://centroidcncforum.com/viewtopic.php?f=60&t=1043

hi, please put all the photos in a online google photos album here is how. #3
https://centroidcncforum.com/viewtopic.php?f=60&t=1043

post a fresh report.zip otherwise we are all just guessing

Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043

use the Wizard to configure your probe.
the message is telling you cnc12 thinks a probe is plugged in and in the spindle since you must have a probe detect input defined in the wizard, either defeat it, configure it properly or remove it.

others have also used differential drivers for connecting Acorn/AcornSix to these drives and others like it to make use of the noise resistant differential step and direction signal.

https://shopcentroidcnc.com/shop/cnc-ex ... out-board/