OK guys
1. I tried all above with no luck.
2. I returned it all to normal terminations. see pic below
3. Motor/driver runs fine now. JUST TO VERIFY encoder and motor cables working....
4. I am going to restart again and install C86 and C34 and try again following above
Search found 35 matches
- Wed Jan 05, 2022 12:07 pm
- Forum: Centroid Acorn CNC Controller
- Topic: CNC4PC C86ACORN & C34 Connection to Closed Loop Stepper driver
- Replies: 25
- Views: 4450
- Tue Jan 04, 2022 10:33 pm
- Forum: Centroid Acorn CNC Controller
- Topic: CNC4PC C86ACORN & C34 Connection to Closed Loop Stepper driver
- Replies: 25
- Views: 4450
Re: CNC4PC C86ACORN & C34 Connection to Closed Loop Stepper driver
There was No fault light on driver flashing
I will try moving drive fault wire to NC contact in C86 tomorrow
The green LED was on above fault relay until drive faults. I will reverify tomorrow.
I will follow up on the above tomorrow and post results here.
Joe M
I will try moving drive fault wire to NC contact in C86 tomorrow
The green LED was on above fault relay until drive faults. I will reverify tomorrow.
I will follow up on the above tomorrow and post results here.
Joe M
- Tue Jan 04, 2022 8:46 pm
- Forum: Centroid Acorn CNC Controller
- Topic: CNC4PC C86ACORN & C34 Connection to Closed Loop Stepper driver
- Replies: 25
- Views: 4450
Re: CNC4PC C86ACORN & C34 Connection to Closed Loop Stepper driver
OK Marty I tried it exactly like you showed. My C34s are newer and have a few more jumpers but I matched yours and my drivers and motors are different. I set the pulse/rev at 8000 also. I also used the bench test screw terminal and set inputs and outputs just like yours. I am getting a 9031 drive fa...
- Tue Jan 04, 2022 1:51 pm
- Forum: Centroid Acorn CNC Controller
- Topic: CNC4PC C86ACORN & C34 Connection to Closed Loop Stepper driver
- Replies: 25
- Views: 4450
Re: CNC4PC C86ACORN & C34 Connection to Closed Loop Stepper driver
Thank you Marty I will try this after work today!!!
- Sun Jan 02, 2022 10:30 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Acorn and C86_acorn Board
- Replies: 3
- Views: 1184
Re: Acorn and C86_acorn Board
I am having the exact same issue in my machine. Was this ever resolved?