Centroid Community CNC Support Forum

When you change any configuration, please generate NEW report.zip and post it. Referring to a report before changes were made does not help anyone understand your system and therefore limits our help.

Why do you need both? If you are intending to combine your 4 closed loop drives + spindle/VFD, you could take a look at schematic S14972 where 3 Clearpaths are setup to combine DriveOK signals using a common 5vdc relay board. Using this technique your additional CL drive is no problem and you could ...

I'm guessing but worth checking your Smoothing settings

Many thanks Uwe

Very interesting Uwe.

Any chance you could post the broaching code?

Tia

Houseman303 wrote: ↑Thu Dec 28, 2023 10:36 am The M30 should reset the display to the beginning of the program, not restart it.

I repeat there is no "should" about it and what are you trying to do other than pick holes in software that functions correctly? Read the manual.

What exactly are you trying to accomplish? You are not correct as there is no "should" about it - Perhaps you mean "I would like to..." M30 designates END of Program and by default, performs no operation. It is therefore understandable that the final lines of your program remain ...

I forgot to mention that it's good practice to Graph a program immediately after loading as a quick and simple error check - something I always do.

As Uwe says, the Edit is there for viewing your code, especially useful when using N++ as the default and configured to your liking

At the end of a program, the display stops at M30. Bug? Definition of: Command M30 ends the executed program of automatic mode and jumps back to the beginning of the program. The definition of M30 is clearly described in the Centroid's Mill Operation manual which I suggest you refer. The September ...

With my Capt. Obvious hat on, don't forget that by doubling the spindle speed you will suffer a 50% torque reduction. Also check that your spindle bearings are suitable for the increased speed.