Centroid Community CNC Support Forum

Hello everyone, This is a promised update on E1616 board installation problem that I experienced initially: I received E1616 board from tech support today and mounted back in it's housing. Did everything as I did after initial installation of the board. With TP-LINK ethernet switch powered up from i...

Arthur I received your Ether1616 today. It works just fine out of the box. CNC12 detected it on first power up and allowed me to assign inputs and outputs in the wizard. I will return it today and when you get it back, I can log in via team viewer and help diagnose this issue with you. Are you usin...

Richards wrote: ↑Fri May 07, 2021 8:11 am Keep us posted after you receive the board back.

I sure will Mike.

Thank you

Arthur, This wasn't the information you were looking for? It came from page 58 of the manual: Ether1616 Troubleshooting.JPG https://www.centroidcnc.com/centroid_diy/downloads/acorn_documentation/acorn_ether1616_setup_guide.pdf Several of us were actively trying to help, until we learned you shipped...

Free tech support is available on the forum if you want to call and talk to a CNC technician one-on-one at centroid for a DIY CNC product the cost is $90 per hour. Warranty is for manufactured defect on parts. If you end up paying for tech support time to determine that it was a manufactured defect...

Marty, After receiving E1616 board and unsuccessful attempt to get CNC12 to autodetect it, as per manual, my first thought was to get in touch with tech support via e-mail. The response was to seek for help on this forum straightaway, which I found very odd, but that's whole another story. After sev...

LED1 7 segment display seems to be causing confusion. *Swirling pattern during start is normal and only lasts a few seconds if set for static IP *Center most segment will light if ETH1616 is ready to run, but is not receiving data *3 middle segments will scroll when running with good communication ...

LED1 7 segment display seems to be causing confusion. *Swirling pattern during start is normal and only lasts a few seconds if set for static IP *Center most segment will light if ETH1616 is ready to run, but is not receiving data *3 middle segments will scroll when running with good communication ...

I'm still wondering about your IP address. You wrote that you're using IP address 10.168.1.43. When I ping 10.168.1.43, I don't get a response. Please check that address. I can't find that address in the 1616 documentation. My documentation says that the address for the 1616 board with the jumper s...

This is a puzzle. I just rechecked everything on my test bench by plugging in all three devices. The computer can ping both the Acorn at 10.168.41.2 and the 1616 at 10.168.41.3. Because I don't normally have the 1616 board connected to my bench test machine, as soon as I started CNC12 Mill, the pro...