Centroid Community CNC Support Forum

I knew I did something wrong in the settings... I just set all unused inputs to unused.

Thanks for all the support.

I have found the cause :D When input 7 ProbeTripped is configured for Input Type NO: I cannot toggle between fast/slow jog. When I change it to Input Type NC, or put Input 7 to unused (so no probe configured): I can toggle between fast/slow jog. Because I am still testing the total setup, I had set ...

I press <alt J> and then <CTRL F> toggle state does not change. Jog axis at 100% feedrate, displayed feed rate = 200 (= slow feed jog speed) Changing fast jog to be the same as Max rate, does not solve the problem. When I change the settings in the wizard to Benchtest, I CAN toggle slow/fast jogging...

Attached the screen copy of the wizard, and the report file.

I have set the microstep value (2000) on the drivers using the dipswitches, the ball srew has 5mm pitch, no other setup.

The distance the table is moving seems correct.

When using the jog keys max speed is 200mm, when I do a G0 X0 Y0 speed reaches 1200mm. Somehow the slow/fast button stays on slow.

I have changed the fast and slow jog settings, and I am clicking the tortoise and hare button.

My settings:
Metric (mm)
Steps /revolution = 2000
Overall Turns ratio = 5
Fast Jog = 1000
Slow Jog = 200
Max rate = 1200

Yes motors turning :) but have a strange issue. Somehow I cannot switch anymore from slow jog to fast jogging. It is stuck in slow mode. I must have done some wrong setting I have to further check. I did change the stepper resolution from 1600 to 2000 in software and on the drivers, this gives a mor...

I send you a PM.

I connected the drivers using the leadshine drawing. I used a 5v power supply. Although the drivers can handle 24v, according to the manual it is recommended to use 5v. I did not yet connected the fault connector. I am still testing the total setup.

I only have to find a way to mount the encoder on my machine. I run a small Optimum BF20L mill in the attic. I replaced the origional motor with a Sangmutan BLDC motor, also from China, running very well the last 1.5 years, and I installed a belt drive from desktopprecision. I run the machine in hig...

Thanks for the great videos, good to see the encoder works. The inside of the encoder (you showed us) looks better than expected, solderings seems to be neat and clean. Today I also received the encoders from 2 different e-bay sellers. The 'Omron' box looks the same like the one you received, only t...