Centroid Community CNC Support Forum

I'm guessing but worth checking your Smoothing settings

Many thanks Uwe

Very interesting Uwe.

Any chance you could post the broaching code?

Tia

Houseman303 wrote: ↑Thu Dec 28, 2023 10:36 am The M30 should reset the display to the beginning of the program, not restart it.

I repeat there is no "should" about it and what are you trying to do other than pick holes in software that functions correctly? Read the manual.

What exactly are you trying to accomplish? You are not correct as there is no "should" about it - Perhaps you mean "I would like to..." M30 designates END of Program and by default, performs no operation. It is therefore understandable that the final lines of your program remain ...

I forgot to mention that it's good practice to Graph a program immediately after loading as a quick and simple error check - something I always do.

As Uwe says, the Edit is there for viewing your code, especially useful when using N++ as the default and configured to your liking

At the end of a program, the display stops at M30. Bug? Definition of: Command M30 ends the executed program of automatic mode and jumps back to the beginning of the program. The definition of M30 is clearly described in the Centroid's Mill Operation manual which I suggest you refer. The September ...

With my Capt. Obvious hat on, don't forget that by doubling the spindle speed you will suffer a 50% torque reduction. Also check that your spindle bearings are suitable for the increased speed.

My router has ER25 Collet spindle and I use Swissi's ProbeApp which is configured exactly for this situation. His mfunc6 is setup to match this config along the lines of Shawn's 2nd paragraph above. The only time I need to slightly adjust the toolchange position is when using a large diameter cutter...

No probs, pleased to help