Centroid Community CNC Support Forum

Everything is working mechanically since I can tell either x or y to go to any coordinate with high degree of accuracy. Just when you go to x0, y0 it fall short of by .2 (diameter of the edge finder). The work around is modify WCS G54 so basically I can't use the edge finder.

Yes, Clearpath is built in to the Wizard. Just select and load.

Just another data point. I modified the X & Y Origin on WCS G54 Table with the .2 difference and G0 x0 y0 worked like a charm and all the g-code operations work as they should be. It looks like the board is not applying the edge finder diameter or it's trying but it's not saving in the nv memory.

Here's a little bit more information that I gathered and I'm pretty confident that it's not hardware but it's a configuration that possibly unique to my setup. 1. I completely reinstalled CNC12 with 5.06 that I donwloaded from Centroid web site 2. Restored all my settings manually. New report attach...

Sorry about that, I wanted to try the caddy corner from the negative side. Here's the result that matches my original description from the positive side. Still have .200 difference.

It looks like the edge finder diameter is not being applied as a move to x0y0 after part setup still yields a .200 difference as you can see from the photo. Please let me know what else to try.

The diameter of the tool is set for 0.200 prior to the F10 save. My part zero is actually right back corner (approach is both positive) and I set it using the space bar. However, I will look at that tomorrow to confirm as I'm not sure if the graphic and where I'm suppose to be is the same. After par...

Just starting with my CNC and this is driving me nuts. I'm trying to drill the center of a part and I'm off by .2 same dia as my edge finder. If I add .2 to my g-code X and Y and I hit the center. I do a Part setup X axis, approach from + and wait for edge finder to break and leave offset as 0.0 the...

eng199 wrote: ↑Thu Mar 10, 2022 5:21 pm wire is shifted over 1 position and the switch is closed.

THANK YOU that was it!!!

I have a new Acorn board and its been working fine with C86ACCP board and ClearPath SDSKs with just default configs. I started to rewire my system according to this schematic S15072.r4.pdf https://www.centroidcnc.com/dealersupport/schematics/uploads/S15072.r4.pdf and all the CNC12 configs required f...