Search found 7 matches

by Rawfodog
Sat Feb 03, 2024 4:04 pm
Forum: Centroid Acorn CNC Controller
Topic: constant fault after update to 5.08 <resolved, wizard not configured properly>
Replies: 10
Views: 643

Re: constant fault after update to 5.08

Thanks. I will make the changes.

Unrelated question but is there a development environment available for CNC12?
Something to use for testing without being physically connected to the hardware?
by Rawfodog
Thu Feb 01, 2024 7:49 pm
Forum: Centroid Acorn CNC Controller
Topic: constant fault after update to 5.08 <resolved, wizard not configured properly>
Replies: 10
Views: 643

Re: constant fault after update to 5.08

I just downloaded it from the centroid site and followed the instructions. I also ran the PC tool before I did the install. I don't think anything was changed. I will get that PDF tomorrow. I was able to rename the new folder and the backup to recover use of the machine at least for now. Runs fine o...
by Rawfodog
Thu Feb 01, 2024 6:03 pm
Forum: Centroid Acorn CNC Controller
Topic: constant fault after update to 5.08 <resolved, wizard not configured properly>
Replies: 10
Views: 643

constant fault after update to 5.08 <resolved, wizard not configured properly>

Hey Guys I am using Clearpath Servos and running the new CNC 12 v5.08x64. After the update today I walked through the wizard and put all my settings back to what I had in the old version 4. I am unable to clear the faults now and I am getting no drive enable bit from the servo board. Also getting a ...
by Rawfodog
Fri Feb 03, 2023 1:24 pm
Forum: Centroid Acorn CNC Controller
Topic: Need a small file to send to Mozaik so they can give me a post processor
Replies: 8
Views: 2434

Re: Need a small file to send to Mozaik so they can give me a post processor

Did you ever get a successful Post from Mozaik?
I am switching to this software.
Having trouble making them understand my home position is in the top right corner of the machine.
by Rawfodog
Mon Apr 04, 2022 9:47 pm
Forum: Centroid Acorn CNC Controller
Topic: New Centroid Teknic Clearpath officially supported configurations. Updated 5-10-23
Replies: 53
Views: 118593

Re: New Centroid Teknic Clearpath officially supported configurations. Updated 1-24-22

I am having issues with my accuracy.
If I jog .100 my router moves .5
I am using the settings provided in this post but not having any luck.

Am I missing a step to tune the distance

I am using an Avid CNC 5'x12 Pro router kit.