Centroid Community CNC Support Forum

hi all, i want do give a small update: the ZRI Homing process is working now ! very happy about it. but i need to use a workaround. since the RS422 Signal cannot switch an Input and the variable in Acorn is not written from the INdex pulse, i use an little Optocoupler transistor from 5V to 24V to s...

Hey All sorry for the delay on getting back to this post - it did come to me after a few beers what my issue was - I didnt have the encoders hooked up and these drives do require encoders to operate. The newer version of the CL57t has a dip switch to turn the closed loop off. But to get back to some...

Hey All - I have a set of Stepperonline CL57T 3.0 stepper drivers that I have bench tested with my board long ago but now theyre not functioning as they should.. or at all ... I have burnt up one stepper motor already The Set Up Acorn Board connected to stepper drivers via DB25 5v logic supply Drive...

thanks for posting the video, i'll take a look at the video later today, in the meantime please post a report.zip so we can see and use your setup. how much backlash does this machine have on each axis? have you seen uwe's and alan's setup / test videos? on this thread https://centroidcncforum.com/...

cnckeith wrote: ↑Wed Mar 13, 2024 7:44 pm post a fresh report.zip

will do tomorrow

here is the vid

I have a video uploading to youtube right now that I'll put the link here once its complete - but what I have found is that if I put the correction value in the next row down it'll work .... as in if you are working on 0.0 > 0.5 instead of putting the variance in the row for 0.5 put it in 1 and it w...

Hey All - I think I'm going crazy - I can't get my Y axis to show any changes when I save distance travel adjustments. The data will save and write to the adjustments screen but with the actual movement of the axis nothing changes, it keep repeating the error. The X axis works fine and I was able to...

Thanks all for the replies - I've used those Omron knock-off sensors. They are open collector normally open (although they are also available as normally closed). The 24V you are measuring is due to the pullup resistor within the Acorn. This pulls the input up to 24V when there is no path to ground ...

SOLVED - Answer at bottom Hello All - I am trying to wire up a homing switch using a NPN NO Proximity sensor on my mill. One of the switches I am using / testing is: https://www.ebay.com/itm/141835552905 NPN Switch.PNG I have searched a good bit and reviewed schematic#: S14955 (https://www.centroid...