Centroid Community CNC Support Forum

When i ran Mach 3 /4 , i had 3 machines set up , i would just start the profile in the Mach loader that i wanted to run . Same machine with different attachments ( spindle - laser - rotary driven lathe ) . How can i setup acorn to do this ??


Ed

Problem was that the e stop switch had 1-no 1 nc switches on it , instead of 2 nc switches.

Wired e stop as per gecko drive only schematic , with stop in nc position g540 green lite on controller , but acorn screen shows red estop . Push e stop in , showes red on g540 , green on acorn screen , no jogging in either condition . New install

Can i use the imac p4-s pendent on the acorn controller , if so how to wire