Centroid Community CNC Support Forum

i have a SERVO3IO with a CPU10
when i go to MDI put in M3S1100 and start the spindle
and then bring up the jog screen ALT J the spindle stops and it will not jog
i have to e stop and reset for any keyboard commands to work
i do not have a pendent
when running a program the spindle runs and all ...

YES you are right it is a servo3io
sorry for the confusion

ok is it possible to connect an mpg to this card

i am trying to hook up a mpg to dc3io
i have an low cost mpg. the computer has an 25 pin header
i need the pin out to hook up the mpg
attached is a report and mpg diagram
thanks

Thanks
That is what I need
I do have the jumpers set
I just wasn't sure if the 3io would handle 12v or 24v
Thanks

i have a servo3io and a china ac servo that i am going to use as a spindle motor
the ac servo drive will take an analog -10v/+10v for input
i have the analog out on the servo3io to the ac drive and it will run the motor
i would like to turn on the servo drive with input 6 srv-on on the drive and ...

For my next dumb question
AC servo for a spindle motor
Will the servo 3 io run it
What is the signal that the board puts out

Thanks for all the help

I have a computer with cnc11 and a 72vdc transformer that is 15 amps

i have a pair of glentek 4020 with the accu coder 755 a
cam i use these motors with the servo 3 io
thanks
H2O

i was gifted a servo3IO rev 010605 and looking for some information on it
i have 2 fanuc 5M dc servos ( 151v and 9A each )and one 0m (96V 7.2 A) will the servo 3IO handle them
i was looking for any documentation on the servo 3IO
any help is appreciated thanks