Centroid Community CNC Support Forum

No problem:

11.4.160 Parameter 263 – DRO Display Precision
This parameter lets you decide the precision of the DRO display by adding decimal points. The default setting 4, which
corresponds to 4 decimals. Ex. 4.1234. Allows changes to the number of decimals show in the DRO. The default
value is 4 ...

If you want to compensate taper from A it will not have anything to do with the rotation of A, it is only a function of XY and XZ movements and the alignment of the rotary A to X and Z.

Get the XY and XZ compensation ok and dial in the A Axis with an indicator along XY and XZ.

Uwe

And I have no time to translate French for helping others in my spare time

It is a matter of respect to adapt your language if asking for help.

Uwe

Filardo wrote: ↑Fri May 16, 2025 1:40 pm Donc vous avez pas de tableau outil après je travaille sur heidhenain ces un autre monde

????

Forum language is English.

I am German and using English also.

Uwe

This option should be an integral part of CNC12. It would make sense for the software to allow setting a program origin and machining directly with the tool’s actual values, without systematically relying on offsets. In traditional machining, these adjustments are only necessary for specific cases ...

On my mill with 5.30 VC is working ok.

But I have full tab tables for XYZ.

One Glitch is that the prob cycles do not use the compensation, instead of X 0.000 Y 0.000 it is setting 0 to X 0.012 Y 0.008 if this is the compensation value for this coordinate.

Uwe

You have only compensation dialed in between X 1.5 and X 13.5
So it will only compensate if you are moving in this range

Uwe

.000010 in = 0.254 µm

Readout from a Heidenhain LC116 scale is 0.001 µm

With an EnDat2.2 converter it is possible to read for the Centroid scale input.

So the readout is not the problem IMHO, but the readout will be better than the position accuracy of the machine.

Uwe

Should be no problem if the axis drive is set up to the requirements.

Uwe

Sure

F4 Run Job Options / F5 Single Block Mode

Uwe