Centroid Community CNC Support Forum

Easy way is Probe APP, otherwise the needed macro is in your keyboard

Uwe

VFD enable triggers the Output# it is assigned to in the Wizard, no matter If you use DB25 or the relayboard.

Since it is not time critical, I use the relay board for the ease of wiring.

Uwe

If a tool is ok for your jobs, do not change it

IMHO the only logical reason for other tools is if they give you an advantage in cost, speed or precision if one of them is at the moment nok.

With wine discard logic

Uwe

That is because the conture is not closed, not all points are connected.

Uwe

i updated TB1 "out of round circles/arcs" https://www.centroidcnc.com/dealersupport/tech_bulletins/uploads/1.pdf 👍 From my experience, you can have nearly perfect round cutting with 0.04mm backlash, if corrected and setup ok, but anything over 0.01 mechanically would show up on the surfac...

I have the Z-Finder from Sorotec, the 3D Finder is better than probes for < 200 bucks, but I have only tested this one from a friend https://www.sorotec.de/shop/3D-Finder---3D-Measuring-sensor-6411-9688.html It is not featuring an angular adjustment, but a good radial adjustment. Kind of soft spring...

This thread is old, meanwile I have changed the CL86T to 5V DB25.

Uwe

Pls. post used g-code.

Uwe

Not sure if I remember right, but this should be fixed in current 5.1

Uwe

Yep, I also would use a small SSR, since ENA is not time critical.

Or if the drivers are enabled by default, I would skip connecting ENA, since CNC12 can force home after E-Stop but not if a single drive is disabled.

Uwe