Centroid Community CNC Support Forum

Just a side note, in both sreenshots, you have loaded T0600, this is Tool #6 with no active offset, T0606 would be Tool #6 with Offset #6

Uwe

One Shots are doing its thing from the current position, that is why I have made a VCP button "Change Tool and rapid to X"

https://centroidcncforum.com/viewtopic. ... ton#p69844

Uwe

They should work.

Uwe

I am running out of ideas....

Next thing I would do is update to 5.10.

Uwe

I am tapping this size with 1500 rpm with good quality taps...

Uwe

P68 ist the speed at the end of the tapping cycle, so you must start at a higher rpm....

Uwe

Why is P68 = 689 and not default 640 ? Your G-code is S 689 like P68.... 11.3.55 Parameter 68 – Minimum Rigid Tapping Spindle Speed (Rigid Tapping Parameter) This parameter holds the value that the spindle slows down to from the programmed spindle speed towards the end of the tapping cycle. The lowe...

Why not use Tool Wear?

Uwe

Stephan wrote: ↑Tue May 28, 2024 11:07 am I'm still hoping that at some point you'll feel like adding a pecking command to G71.

As I said, thanks again for SSV

Greetings Stephan

That can easily be done in fusion, though I would prefer G71 pecking in Intercon also.

Uwe

JMC servos are featuring an Z max. 100mA output that can be directly connected to an Acorn input.

Uwe