Centroid Community CNC Support Forum

That is because the conture is not closed, not all points are connected.

Uwe

i updated TB1 "out of round circles/arcs" https://www.centroidcnc.com/dealersupport/tech_bulletins/uploads/1.pdf 👍 From my experience, you can have nearly perfect round cutting with 0.04mm backlash, if corrected and setup ok, but anything over 0.01 mechanically would show up on the surfac...

I have the Z-Finder from Sorotec, the 3D Finder is better than probes for < 200 bucks, but I have only tested this one from a friend https://www.sorotec.de/shop/3D-Finder---3D-Measuring-sensor-6411-9688.html It is not featuring an angular adjustment, but a good radial adjustment. Kind of soft spring...

This thread is old, meanwile I have changed the CL86T to 5V DB25.

Uwe

Pls. post used g-code.

Uwe

Not sure if I remember right, but this should be fixed in current 5.1

Uwe

Yep, I also would use a small SSR, since ENA is not time critical.

Or if the drivers are enabled by default, I would skip connecting ENA, since CNC12 can force home after E-Stop but not if a single drive is disabled.

Uwe

This chart was supplied with the probe I guess? I have used some types of probes in the <200€ range and made probemaps with them. Non was as good as a KP3, but maybe ok for hobby. But for me, the most annoying thing was that none of the cheap probes stayed in center for a longer time and some of the...

Stepper with ENA from the Headers, Step/Dir from DB25

https://www.centroidcnc.com/dealersuppo ... 032.r2.pdf

Uwe

Easy way to solve this is a timer relay in the servo enable wire active at power on.

Uwe