Search found 4 matches
- Wed Aug 31, 2022 7:02 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Tool Library and Fusion 360
- Replies: 4
- Views: 888
Tool Library and Fusion 360
Hello the question I have is about the tool library in Fusion360 and the one in cnc12 when i post g code for a part will cnc 12 recognize the tool number and offsets from fusion or do they have to match the one in the cnc12 library? is ther a way to reset the Tool library in cnc12 I have been lookin...
- Sat Jun 11, 2022 1:00 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Auto square question
- Replies: 1
- Views: 493
Auto square question
I have my machine wired with simple lever limit switches . I would like to add Proxcimity switches to the Y Axis for Auto Squaring the Gantry is it possible to wire them in and leave the X and Z Axis with the lever switches looked at at Diaghram for the Home-all wiring and not sure
Any advice
Any advice
- Sat Oct 23, 2021 5:36 am
- Forum: Centroid Acorn CNC Controller
- Topic: New acorn Board and a few questions
- Replies: 8
- Views: 2376
Re: New acorn Board and a few questions
Thank you for the replies all the info was very helpful and got me on my way to motor travel and seems that the motor tuning has worked as well. this forum and all the info is very helpful did a lot or reading on steppers may upgrade in future now knowing all the info. have been looking at a subject...
- Sun Sep 26, 2021 5:30 am
- Forum: Centroid Acorn CNC Controller
- Topic: New acorn Board and a few questions
- Replies: 8
- Views: 2376
New acorn Board and a few questions
Hello I recently purchased the acorn board ,Did the benchtest and all went well so far. I've been do ing a lot of reading on the forums and they are very helpful, but I still have a few questions. I try to give you as much info on what I have Bulkman Cnc 3 Axis/ 4 Motor router - https://bulkman3d.co...