Centroid Community CNC Support Forum

back at it, just checked output status of enable terminals,
ena led red,
axis 1=23.6v
'' 2=150 mv
'' 3=125 mv
ena led green,
axis 1=23.6v
'' 2=175 mv
'' 3=23.6v

Hi guys Marty, I have been at it again. First off i have been making changes in the wizard. Today i emailed Keith with centroid and he asked to perform a few things then post a report. At the moment all connections are as they were when i started. after doing what Keith suggested the outcome is the ...

I came in this morning and swapped all my connections to db 25 connector and the results are the same , no drive on 1 and 2

Wiring is all correct,i am using the the header connectors. As per my first post i did have a loss of power during a restart which is when this started.

i have just changed x axis over to a and it worksas it should,i have attached the new report.

Acorn z runs any drive motor combination as it should.

Marty, I just finished checking to see if after jogging the z axis which works is locked after the move,the x does not work and stays unlocked,and y stays locked and it also does not jog. If i power only the drives and not acorn all motor rotors are locked. All of the drive enable settings are the s...

Sorry but i have no idea where that report is from but this one i added is the actual report from 9-7 21

Hi guys, I iv just finished up doing an acorn install on an old bridgeport r2c3 cnc mill. Once all tests were done all axis were working,machine would home all was looking good i was just waiting for my vfd to arrive to finish up. I went in the shop saturday to start setting up for the vfd and after...