Centroid Community CNC Support Forum

OK, understood. I'll contact you off line directly.

Thanks

Julian

Hi Mark, Thanks for the info. Firstly you are correct in that if I start the spindle manually then I can open the door and it still runs. Also the program will start with the door open and the axis move but it will stop when a spindle is commanded, I’d rather the axis did not move, while in auto, at...

Hi,

When I press feed hold and open the door the program aborts. I’d like to be able to close the door and continue. I can’t see any parameters related to this on the Oak. I can see Acorn has 985 that looks related, but that does not appear on the OAK

Any ideas?

Thanks

Julian

Thanks, it's working now. I was putting +5v to the inputs!

Hi, I’m wiring up my own MPG, axis and multiplier selector on an Oak. I’ve followed the wiring diagram for H19, but I can’t get anything out of it. What’s odd is that I can’t get any of the inputs, so INP773 through INP783 to signal on the PLC diagnostics. I can’t even invert/force them with ctrl + ...

Success!!

That did the trick, thank you so much. For reference TB267 says: "308-310 should be set to 7, 8, and 9". May be worth adding that Oak requires 1, 2 and 3

Best regards

Julian

My post seems to have gone from last week. Not sure why, so I’m starting another. I was chatting to @cncsnw who was very kindly helping me out. I have recreated the thread as best possible Original message @Talyond wrote: I’m setting up as per technical bulletin 267, but I have a CNC12. All cables w...

@ashesman. I've purchased a single Yaskawa drive and motor. Just sorting cables out, if they work I'm moving on. Keep you posted.

Thank!

@cncsnw. Not tried that 120v, but like you say that's hard to come by. I've purchased a single Yaskawa drive and motor. Just sorting cables out, if they work I'm moving on. Keep you posted.

Thank!

Julian

Thanks @ruirosa unfortunately I had the new drawing so was already wired that way:(

Julian