Centroid Community CNC Support Forum

Apologize for delayed response. Had back surgery and was down longer then expected. I am back at work and the table is working. It was all settings and after speaking with Joey, I had a better understanding of centroid and where I needed to improve. Joey explained how important the "Plot" is and he ...

I sure do, I am sending an email with all my contact information. Thanks

OK, I bought a new computer thinking maybe it was the "Guzilla" brand(Knock off NUC) so I bought a lenovo and did a fresh install, ran Centroid PC tuner and connected. Set it up and performed first Hook cut. Did the exact same thing, THC isnt reacting. Any ideas what it could be?

I changed everything, I had to uninstall intercon and reinstall for it to show imperial. However, the thc still acts the same. No matter what I changed to imperial it would not change on centroid. I dont understand that but it is what happened. Weird

I even tried 3 extreme, well what I felt was. I ...

Thanks for the reply, let me go change this and test. I'll be right back

Much appreciated, when I check it shows enable on the second pop up window when setting parameters. Is there a secondary setting? This is a fresh install, if that makes a difference. It cuts beautiful on .18 a thicker. Holes are off by .01 which for what we do is good. The table will be used to make ...

Hope this works, thanks for the help

I will do this first thing in the morning when I get to work. Thanks

Just tried it, no changes.

Joey thanks for your reply, I never tried that setting, always left it with automatic. I will try that setting now and be right back