Centroid Community CNC Support Forum

Best bet is to Contact Hypertherm.

I think I remember someone on YouTube rigging up a hand torch. I think it was Clough49. It was a 45xp but the larger Power max hand torches should be the same.

Any Luck Zagga?

Do you have Internet on the machine PC?

I can help switch you to the plasma software through team viewer.

The Acorn and CNC12 software will be non the wiser if the Plasma unit is powered on or OFF. Power cycling the Hypertherm won't affect anything Bak who is on the Forum here recently hooked up his hand torch and made the changes necessary inside the hand torch. Bak called Hypertherm and they Instructe...

Download and install the latest acorn plasma software V5.08 at the link I provided in my last post


Don't worry about the license for now

Welcome to the forum. Thank you for the Report. Can you please attach the Gcode jobs you are running when the Z locks up. I want to see the Gcode job you a using. You best chance at having a working Plasma table with the Acorn is to Download and install Acorn Plasma software. Your current software i...

Checked out the Latest Plots yesterday The Last Plot was not looking good. Tiny Man Plot.png Turn the Plot capture on in the F7 Utility menu and dry run some jobs. This will capture plots without the torch running to see what the Cabinet is showing. Refrain from firing the Torch until this is resolv...

I would double check the divided voltage lines going to the TX board from the Hypertherm to ensure the Correct pins were used on the Hypertherm. In your picture the red going to the ANLV and Black to the GND make me nervous. PIN 5 from the Hypertherm is the Negative of the Devided voltage and goes t...

I think this has something to do with the calibration when the first TX was damaged.

Try a fresh install to get back to 0.

You can select CTR P when on the wizard to save the Wizard settings with print to PDF.

No problem

The THC should be set to installed during the Torch calibration.

Can you post a picture of the profile and THC config settings?