Centroid Community CNC Support Forum

Good choice on switching to the Everlast Torch Touch with Everlast and Primeweld is not officially supported by Centroid. I haven't seen another Everlast Using the TX torch touch yet. What does the Tin Wire connect too? I have seen the Primeweld Hooked up to the TX boards Torch touch and it seems to...

Lowering the Parameter P223 should help with Arcs. I wouldn't take P223 below 100. Setting the Drives to 6400 and the wizard to match should also fix the speed up issue. The Laser offset issue is puzzling. I've even loaded your report on a fresh 5.08 build and Laser set X/Y functioned as expected. I...

Did you try the different duplex settings? I've seen some PC's that needed the Duplex setting changed or manually set.

100mps or 100 Half duplex or 100 full duplex.

Those are some nice cuts. Clean and smooth. Is the Wizard set to 3200 steps/rev for X and Y? I think the last report I saw something like 6400 Can you post a fresh report with the latest settings. Can I see the dip switch settings on the drives? Did setting Parameter 223 to the 100-300 range help?

Seeing a lot of com errors in the msg log.

Have you tried disabling the windows firewall completely?

I run a CnC plasma but instade of firing the torch stops and Rises up. Could this be something that would be solved within the software.. Your Machine with Acorn Mill is Controlled by the Gcode completely. If the Job stops without an error in the message LOG. it was most Likely something in the Gco...

Download TeamViewer
https://www.teamviewer.com

What Kind of Drives are on X,Y and Z? Is this a direct rack and pinion table?

Pictures of each axis and the drives would help

Can you post some of the G-code jobs from the example Pictures. Does the same thing happen without smoothing? Try setting parameter 223 to 300 Path to the Parameters list from the home screen is F1 Setup>F3 Config>F3 Parameters This will Lower the Vector rate with smoothing and should help for smoot...

I was not able to replicate the issue with your report.

Usually, the X moves in the G-code I tested with was very short and the distance to go was shown briefly since the X move was very short and quickly executed.