Centroid Community CNC Support Forum

I run a CnC plasma but instade of firing the torch stops and Rises up. Could this be something that would be solved within the software.. Your Machine with Acorn Mill is Controlled by the Gcode completely. If the Job stops without an error in the message LOG. it was most Likely something in the Gco...

Download TeamViewer
https://www.teamviewer.com

What Kind of Drives are on X,Y and Z? Is this a direct rack and pinion table?

Pictures of each axis and the drives would help

Can you post some of the G-code jobs from the example Pictures. Does the same thing happen without smoothing? Try setting parameter 223 to 300 Path to the Parameters list from the home screen is F1 Setup>F3 Config>F3 Parameters This will Lower the Vector rate with smoothing and should help for smoot...

I was not able to replicate the issue with your report.

Usually, the X moves in the G-code I tested with was very short and the distance to go was shown briefly since the X move was very short and quickly executed.

This is a result of pressing write setting with the Custom ATC macro set to yes. Doing this is making an assumption that the user will set these parameters manually. What most people do is have the slider set to no press write setting to cnc control at least once which sets all ATC parameters proper...

The M61 Macro can be Customized to Operate differently. Can you Post some example Gcode of a Wiggle Peirce? I'm assuming you would be looking for something like. M61 is called Touch off cycle and the Z retracts to the Pierce Height. The torch is fired and X Y motion starts for the Wiggle pierce. Aft...

The Wiring looks the same. Schematic S15034 will work. You want continuity from the stand offs all the way thru to the cabinet. All ground and Shields should be Attached at a single point bar or terminal strip Not 100% sure on the stand off length but I think for the Acorn at least a 1/4 inch length...

I was not able to replicate any issues or the Laser offset in the Wizard not working.

Id be happy to try a TeamViewer session with you to try and pinpoint this issue.

Wow, Good on ya for finding the Issue. That sounded frustrating.

Thanks for sharing the Conclusion and Lessons learned