Centroid Community CNC Support Forum

Character display problem now. Same version 5.1RC5

Hello,
Ok, setting Par 406 to 0 did the trick. Wizard writing issue I guess.
Thank you
Bill

Trying out 5.1 RC5 today. Auto Z to plate not working. I have a NC TT device setup in the wizard as mechanical, input state when triggered=open This shows to be working correctly in the diagnostic screen, however when using auto z to plate it doesn't work. Z keeps moving until it triggers the over t...

I am having an issue with tool offset measurements as well with the new probe logic. I have a fixed TT device setup as "tool touch off triggered" on input 7. Configured as mechanical/NC - open when triggered. I also have a movable TT device, same device, connected to the same input for set...

I tried 5.1 last week. got everything configured with entering all setting thorough the wizard. I did copy over my tool library and tool offset folders from 5.08 After that I am getting an error that I have not seen in a long time. It is the "can't save tool library" "can't save offse...

I think but I'm not sure.
It is called "probe_move_to_surface"

Bill

The feed rate and rapid rate are separate now. Dialing back the rapid rate will affect your jog speed.

I have an S30c and wanted to setup SV feature. I will have to try this out.
Bill

Hi Keith,
Yes, I know that. It is off.
Bill

Yes.