Centroid Community CNC Support Forum

Check software travel limits in Wizard. Just set the negative value to 999 for test.

Manually digitize the 16 points needed, and recreate the part by hand. You could probably have that done in the time it takes to set up the digitizing routine.


Well you are right, but other parts are much more complicated than this one and they have a lot of strange curves which have to fit ...

Hello, we have recently purchased Acorn board and have been setting it up for a while, did some test runs and it's just wonderful.

The problem is that we work with large parts (all up to 6 x 2 meters) which we want to digitize (100 parts or more) at lower resolution but still get all the corners ...