Centroid Community CNC Support Forum

I found a picture from when I made my cable and a photo of my cable. Don't laugh at my wiring, I made it in a hurry one night! The heatshrink contains resistors required to bias the RS-485 driver. Some cables need them and some have them built in. For example older FTDI drivers (very commonly used)...

Look in the C2000 manual, it has a picture. You only need to co next + and -. Its not a bad idea to also connect gnd but 5v is not required. I have seen a photo of the RJ45 connector but there are duplicate signals, 3 and 6 ground and 4 and 5 sg+, I have to duplicate them also on the RS485 output.

ashesman wrote: ↑Sun Mar 17, 2024 5:57 pm Download for free from the delta website.

Note that some of those rs-485 cables require resistors to be wired between 5v/gnd and the a/b signals. Check the manual for the adapter you get.

The adapter they will give me has 4 outputs, gnd, 5v, trx+, trx-. Which RJ45 pins should I connect them to?

It's just three sets of motor ratings. You could use any of them. You could use the lower frequency data for the rated values and set max frequency to the highest. But using the upper set if you intend to run it at the upper range is probably most accurate. Your problem is over current error during...

Ok, thanks for the information, tomorrow I will try to solve this configuration problem, I have checked the motor parameters again, on the motor plate there are 3 voltages, 3 speeds, 3 amps, 3 rpm. I have only entered the data for the third voltage. , third amperage and third speed, I don't know why...

Which part of the instructions is giving you problems? 1. Set speed on VFD to 1/3 of rated speed 60Hz = 20Hz 2. Set acceleration/deceleration time 1.5 seconds (01-12, 01-13) 3. Set 11-00 = 2 , Inertia auto-tuning 4. View 11-01 during tuning 5. Press forward and reverse until the inertia is stable. ...

Have you let the drive go through its self tune procedure to characterize the motor? This motor appears to be an induction motor, are you running the drive in induction motor mode? Honestly, I am going to keep saying it... You need to start diagnosing the problem. There is probably no-one that can ...

Ok, yes I have done an automatic adjustment but with the motor stopped, I have not done a dynamic adjustment because I do not want to remove the spindle belts, in the manual it says for dynamic adjustment of the engine without load. I will try to find a cable. Thanks anyway

Hello, the configuration of the motor was discussed in this thread and I think everything was clear, anyway I am attaching the motor data, plate data and manual, it is a 4-pole motor with abz 1024 encoder and I have it configured so that Work at 230v, 272hz, 26 amps and 8000rpm as indicated on the p...

The error is (ocd), the motor is connected to the spindle with a belt, there is nothing else. Do you know the link for the delta support.