Search found 3 matches
- Wed Jun 23, 2021 8:23 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Z Axis only traveling in -neg direction...(Resolved)
- Replies: 20
- Views: 5248
Re: Z Axis only traveling in -neg direction...
The problem I had was that the stepper drivers failed (2 of them) for direction. They never changed direction. I isolated it to a resistor on the input opto isolator for direction (open resistor). I sub'd a replacement resistor in and everything worked. I suspect I somehow put to much voltage on the...
- Fri Jun 18, 2021 4:47 pm
- Forum: Centroid Acorn CNC Controller
- Topic: Z Axis only traveling in -neg direction...(Resolved)
- Replies: 20
- Views: 5248
Re: Z Axis only traveling in -neg direction...
I double checked all wiring - no issues. I checked the dir signal to both drivers and everything checks out. It also matches the other driver dir levels. I decided to swap the driver with the 4th axis driver (currently unused) to see if it is the driver. The 4th axis driver worked fine running as th...
- Fri Jun 18, 2021 8:15 am
- Forum: Centroid Acorn CNC Controller
- Topic: Z Axis only traveling in -neg direction...(Resolved)
- Replies: 20
- Views: 5248
Re: Z Axis only traveling in -neg direction...
I am new to the Centroid Acorn product. I have a homemade CNC with dual drives for the Y and Z axis and a single drive for X. I have also recently experienced this same issue. I started the system up and did a home step and the X-axis only would move in the positive direction. After some playing aro...