Centroid Community CNC Support Forum

I want to thank you all for your help, it was indeed a firewall setting that needed to be changed.

I have checked all the voltage inputs and swapped out the network cable. I have tried starting the software separately running as administrator but the problem persists. The LED status window displays 1. I look at the Windows Firewall exception again.

I get the same results with pinging IP address: 10.168.41.2
I am assuming the cable is good by the ping test but I can try another cable and I will test the power connection next. Thank you for your help.

On power up today the control reports "Timeout: MPU not responding". I checked the static IP address and it is 10.168.41.1. I also made sure that there were no firewalls enabled or antivirus software enable. When I open up a command prompt I am able to ping the control without issue and th...

I am installing an OAK control to replace an old PC control in a single punch machine with an X and Y axis attached to a flat table that positions a piece of sheet metal under the ram to be punched. The machine is equipped with a homing proximity switch on both the X and Y axis and when the machine ...