Centroid Community CNC Support Forum

Forgive my ignorance … if M3 will run the acorn controller then yes ? I literally inherited a disaster . Old Pic below . So I bought an acorn controller and new computer . Started over from scratch . I have managed to get the x,y,z axis functioning properly with cnc12 . It will run a cut file . But ...

Need advice ? Just received a free plasma table...all motors and and Anaheim automation boards all attached . Ordered a controller from acorn. Will I need a special cncpc and a separate computer? Or can I use a high end computer and download acorn software and get this thing up and rolling ? Post p...

Same issue … I’m can run without THC . I just need to know where to wire the torch start . So I can fire the plasma torch . Thanks

Need advice ? Just received a free plasma table...all motors and and Anaheim automation boards all attached . Ordered a controller from acorn. Will I need a special cncpc and a separate computer? Or can I use a high end computer and download acorn software and get this thing up and rolling ?