Centroid Community CNC Support Forum

I also tried adjusting parameter 814 in every setting and still no change in voltage

Well I tried disconnecting all probe system wiring and still no change in the voltage. Steady 0.523V no matter what I do. If powered off the analog out will show no voltage once power is restored the voltage will read 0.523V immediately and stay at that voltage regardless of command. I'm wondering I...

Ok thats good idea let me try that and reply back, is there a chance the control board is faulty and or what would have caused that.

Is there any settings and or parameters that maybe causing this voltage problem? Ill have to double check the wiring again to see if Im missing something, as far as output to the VFD I just have forward and reverse and obviously the analog out and com.

Yes I did do the bench test procedure prior to installing the Acorn board. I was getting the correct outputs at the terminals while doing some VFD calibrations etc. However after switching control system enclosures I noticed the issue Im having now.

Hey

I have the multi meter connected directly to the pins of the Analog terminal, took the 2 wires out and installed the meter leads into it. I do have the motors and homing switches etc connected to the board but nothing else connected to analog out terminal.

Hey guys I just replaced my machine electronics enclosure with a larger on for better space etc. For some reason Im not getting the 0-10v output from the spindle analog out port. Right now Im getting 0.5v all the time regardless of MDI command I tried the spindle bench test again and Im getting inco...