Centroid Community CNC Support Forum

Is this one of those under $50 Omron knock off encoders from Ebay?

Even worse, from Alixpress, i´ll buy a new one soon from a know distributor.

Cheers

Hi everyone, thanks for your help, well it wasn’t a wiring problem, like cncsnw said, it was only reading one channel, I used the oscilloscope to see if the channels are ok, and I only have the A channel working, I use one of those pot inside the encoder until I get a reading on the B channel and th...

tblough wrote: ↑Mon May 10, 2021 9:55 pm An April 26th report is not going to help very much. Can you create a report after the encoder installation?

Hi i replace it with a new one

Best Regards

Well after i bought it i found out that there are a lot of knock off.

I replaced the report file witha new one

Regards
Daniel

Hi Everyone i'm Daniel from chile, i recently bought an encoder E6B2-CWZ1X 2.500 p/r 'cause i want to cut threads in my lathe (i have an Acorn Board), i wiring up like the acorn documentation said, i activated the encoder from the Wizard, enter the 10.000 counts on the dialog box, restart the CNC12 ...