Centroid Community CNC Support Forum

here is the report

Its the drive that is in alarm the acorn remains in green mode

As for the alarm I would Power down disconnect the motor power and encoder. power up reset and move that axis and it would alarm only at 75% or higher. I think that points to the relationship between the acorn and the drive eliminating the motor.

Thanks I will try that.

Ok i am a lot further then i was a few days ago so here we go. I have bench tested my nema 34 12nm motors and my rattan 2HSS86 drive. all three rotate. the problem is they rotate only to 75% federate then it sends the drive into alarm ( more than 3 blinks per/second the alarm is described in the att...

I am a first time centroid acorn diy guy. I am just about finished with my install I have not powered up at all. I have a local guy that i want to do quality control before I power up. however i have limited access to him. My issue is the end stops I am using they are Omron Automation And Safety EE-...