Centroid Community CNC Support Forum

Question for Shawn, When trying to Run the DMM Dyn4 Test like in the below, should the Dyn4 still be hooked up to Acorn6 Control? https://www.dmm-tech.com/Files/DSFEN_A1403_1217_p.pdf On page 3 of the above Referenced Manual it states that the DB9 Encoder Connector should Not be Connected to the JP5...

Thanks Shawn, I changed IN14 from NC to NO on the "Axis1DriveOk" and now the Dyn4 no longer Faults. This is an Acorn6 and the Wiring Diagram S15164.r1 shows connecting the Axis1 to the Input14 as seen in the attachment below. I am only following what Centroid has provided. If it really sho...

Ok, so we Removed DriveOk from input 5. 1) Then we Tested Axis 1 "X" which is also DMM1 of the Dyn4 Driver and upon powering up everything the Green LED on DMM1 comes on upon Reset on the VCP. 2) When we try to Move X+ or X- we get an Message 9025 Axis 1 Drive Fault Detected. Pressing Rese...

Here are the Settings for Input and Output currently and the Report.

In5 NC DriveOk
In8 NC Estop
IN14 NC Axis1DriveOk

Out1 NoFaultOut
Out16 Drive Reset

Regards,

Preston

Thanks Shawn and Keith... Sorry, I stated the Wrong Type of Estop... It is a Dual Normally Closed Type as I purchase it from Centroid. I changed the Setting in the Wizard and it is all back to working now including the Magnetic Contactor.. So now on to configure the DMM Dyn4 to the Acorn6. I followe...

Hola Shawn, Ok. 1) I set Output 1 in the Wizard to "nofaultout" and Restarted CNC12. The Reset button in the VCP now does Nothing, But, if it Push the Manual E-Stop the Contact Engages and the E-Stop is Removed. Exactly the Opposite of what we want. And Input 8 which is E-Stop is set to NO...

Hola Shawn, 1) Ok, that is the First that I have heard of the VCP is Not the Same as E-Stop... Thanks for that!!! 2) I Do have Output 1 wired as per S15164.dwg and it was Enabled before I did the Drive Config. 3) Ok, so by Loading the Drive from the List I screwed up my Inputs and Outputs...Great! 4...

Hello Everyone, Well Chuck with Centroid helped me get the Estop and Magnetic Contactor troubles worked out and everything tested out well. Until this morning after wiring in the First DMM DYN4 we went into the Wizard and did the following: 1) In the Axis Drive Type we Selected the DMM DYN4 2) Then ...

Update: The AcornSix board that Centroid Checked Out and was fine arrived back and we reinstalled it into the Control Panel. Hooked it back up to the Centroid Control CNC12 Computer and still no communication. Contacted Liviu at Centroid and he did another Teamviewer session and could not get any co...

Thanks Shawn,

From everything I have been reading and seeing, I believe your advice
agrees.

I will use all of the NF's and F's indicated and keep them very close
to the DYN4 Drives.

Thanks for your kindly reply.

Preston